Mixing, granulating, heating, reacting, drying, cooling

The range of options for exercising more accurate control over product properties can be broadened by supplementing the Eirich mixing technology with task-specific peripheral drying equipment.

Fundamental process engineering operations such as mixing, granulating, heating, reacting, drying, cooling can be implemented simultaneously or one after the other in just a single machine.

This is achieved with innovative Eirich technology which can be tested with the original materials at the Eirich test center:

  • Laboratory technology (including Ex-proof) for contact drying under atmospheric pressure and vacuum contact drying
  • Vacuum hot vapor dying in Evactherm® mixers operating in closed circuit mode with integrated evaporation cooling
  • Drying of aqueous material systems with hot air or flue gases
  • Emission-free drying (Ex-proof also available)

A summary of the advantages of Eirich drying technology:

  • Any consistency can be processed without problems – no need for pre-conditioning
  • No material build-up on heated walls or installed parts
  • Granulates with the highest densities/powder densities
  • Seals are not in direct contact with the product
  • Easy change of formulas with short start-up and stop times
  • Moisture and product quality adjustable over a wide range - from powdery to granular

Eirich can offer special expertise in the following areas:

  • Grinding disk compounds
  • Modern high-performance oxide ceramic materials
  • Nanoceramic materials
  • Pesticides
  • Detergent compounds
  • Friction lining compounds (clutches, brakes)
  • Isostatic refractory compounds
  • Cellulose derivates
  • Aqueous or solvent-based pastes, suspensions, slurries
  • Metalliferous sludges
  • Lacquer/paint sludges